01-11-2018, 02:08 PM
(01-11-2018, 12:10 AM)Zeropage Wrote:(01-10-2018, 12:28 PM)admin Wrote: The CSLoad doesn't connect to commodore server, and it doesn't show that it is trying to dial it either. However, I do see: "Device 2 opened ok" and "Device 2 write ok" messages. The formatting for the response messages changed with v2.0 firmware. Would this make a difference? I think I deleted a CR/LF.
Hi Jim
I dont see why it would..
But that raises another question. Are you expecting a CRLF at the end of the ATDT command ? I'm only sending a line feed (\n).
I'll try it with \r\n and see if that makes any difference.
No, I look for either /r or /n for the line termination.
It seems like the PRINT#2 that sends data to the modem is not being accepted, almost like the handshaking is not correct. I changed a LOT of things with v2.00, so I will look into that.