at*help still says ATI!

[scanword]

You need to set your terminal to 300 baud.  As stated, the new update reset ALL of the settings, including the baud rate.  The Loader program expects the baud rate to be 2400 baud for it to switch into 38400 baud mode.  So, you need to switch to 2400 baud and save that baud rate using AT&W.

hi tomorrow i have write this in wimodem to reset :
at*2400 return 
at&w  return 
ok now the wimodem is ok to 2400 baud for work with terminal program zterm 

and after i load the commodore server driver loader  but after procedure the wimodem dont connect to commodore server .......
with other firmware  it  work ........
i must do another command to my wimodem to connectly aotomatically with this program (driver loader commodore server  )??