09-12-2018, 08:39 PM
(08-27-2018, 06:55 PM)Sprite9 Wrote:(08-22-2018, 05:49 PM)admin Wrote: Did you follow the Q-Link information below?
https://www.cbmstuff.com/forum/showthread.php?tid=329
A lot of people miss the fact that DCD must be set to on or Q-Link will ignore the connection, just like what you describe.
I did follow that information, and in the first post here I included the results of AT&V which shows a status of "&C0" which I believe from the manual and the post you linked to mean that DCD is always on. Also Baud rate is shown to be 1200 and using the spoofed number a successful connect is shown.
For the next step I will try an unvalidated Q-Link disk. Thank you for your help as I trouble-shoot this problem.
Turns out that AT&C1 is needed to connect to Q-Link, which is contrary to: https://www.cbmstuff.com/forum/showthread.php?tid=329 as well as some old notes I had.
Setting AT&C1 solved my problem and works with the 3.0 wimodem software.