Anybody else having a problem storing numbers with the AT&Z#=ADDRESS.TLD:PORT command? It used it a lot before, but haven't for a while. If I (for example) try to store Orbit BBS with the command at&z1=orbitbbs.ddns.net:7210 it just doesn't respond.
My old WiModem had an unfortunate (physical, not the fault of the modem) accident and I recently got a new one. I don't know why, but I can't seem to add any numbers to the address book now. I'm not sure if this would have been the case with my old one or not because I hadn't used that feature since December - I know that one of those firmware updates reset the modem configuration to defaults and I hadn't tried to add anything since then.
Anyhow, when I try to add an address to the list, I don't get an error message, it just doesn't respond at all when I hit enter. Doesn't even linefeed, just returns the cursor (CR) to the beginning of the line and acts like I didn't even type anything, and the at&z? list is still empty.
My old WiModem had an unfortunate (physical, not the fault of the modem) accident and I recently got a new one. I don't know why, but I can't seem to add any numbers to the address book now. I'm not sure if this would have been the case with my old one or not because I hadn't used that feature since December - I know that one of those firmware updates reset the modem configuration to defaults and I hadn't tried to add anything since then.
Anyhow, when I try to add an address to the list, I don't get an error message, it just doesn't respond at all when I hit enter. Doesn't even linefeed, just returns the cursor (CR) to the beginning of the line and acts like I didn't even type anything, and the at&z? list is still empty.