07-29-2016, 06:56 AM
To use 38400 in V-1541, is this the right procedure?
1. Issue in a terminal:
AT&K1
AT*R0
AT*C0
AT*B38400
2. Change terminal's baud to 38400
3. Issue ATDT commodoreserver.com
4. Leave terminal
5. Run V-1541
I haven't successfully been able to communicate with the WiModem itself at 38400 yet. I assume the AT&K1 to enable hardware handshaking is necessary, as it is in 9600 mode.
1. Issue in a terminal:
AT&K1
AT*R0
AT*C0
AT*B38400
2. Change terminal's baud to 38400
3. Issue ATDT commodoreserver.com
4. Leave terminal
5. Run V-1541
I haven't successfully been able to communicate with the WiModem itself at 38400 yet. I assume the AT&K1 to enable hardware handshaking is necessary, as it is in 9600 mode.