Using higher speeds...?
#2
The WiModem actually works up to 4 megabaud, but the stock firmware is limited to 230,400 baud. I have a new mode where I can link two WiModem232's together (without going through the router) to act as a NULL modem cable.

Are you setting the WiModem232 to 38400 baud BEFORE you make the change of this device to the higher speed? Is this device REALLY switching the communications to 38400 baud? Is this device expecting any type of RTS/CTS/DTR/DSR/DCD configuration?
Reply


Messages In This Thread
Using higher speeds...? - by DarkLord - 01-05-2023, 09:40 PM
RE: Using higher speeds...? - by admin - 01-06-2023, 02:51 AM
RE: Using higher speeds...? - by DarkLord - 01-06-2023, 03:46 PM
RE: Using higher speeds...? - by admin - 01-07-2023, 02:16 AM
RE: Using higher speeds...? - by DarkLord - 01-07-2023, 09:01 AM
RE: Using higher speeds...? - by admin - 01-07-2023, 01:13 PM
RE: Using higher speeds...? - by DarkLord - 01-08-2023, 01:07 AM
RE: Using higher speeds...? - by Craziazkowboi - 01-08-2023, 02:16 AM
RE: Using higher speeds...? - by DarkLord - 01-08-2023, 06:30 AM
RE: Using higher speeds...? - by admin - 01-08-2023, 03:52 PM
RE: Using higher speeds...? - by DarkLord - 01-08-2023, 07:46 PM
RE: Using higher speeds...? - by admin - 01-08-2023, 10:25 PM
RE: Using higher speeds...? - by DarkLord - 01-09-2023, 09:06 AM
RE: Using higher speeds...? - by admin - 01-10-2023, 04:43 AM
RE: Using higher speeds...? - by DarkLord - 01-10-2023, 05:18 PM
RE: Using higher speeds...? - by DarkLord - 01-20-2023, 12:13 AM
RE: Using higher speeds...? - by admin - 01-21-2023, 11:23 PM
RE: Using higher speeds...? - by DarkLord - 01-22-2023, 09:40 PM



Users browsing this thread: 1 Guest(s)