10-25-2022, 01:49 PM
I am testing the new S-Register (S73) support. However, when adding this I noticed that I forgot to add the saving of S-Register S30 when I added the inactivity timer support! This means that on power-up S30 would always be 0 (no inactivity timer). So, if you did not have S30 in your init string for your BBS because you thought this was saved with AT&W, then it would never have this active if the modem was powered off and on. I have fixed that.
The new S-Register S73 represents the maximum connection time in minutes. So, a value of 1 would terminate a connection after 1 minute. A value from 1 to 255 (to up 4.25 hours) can be used, with a value of 0 being OFF. The default should be 0 (OFF) for any WiModem made in the last couple of years. Doing a factory reset (AT&F) would definitely turn it off.
I will let you know when testing has concluded. It could happen later today.
The new S-Register S73 represents the maximum connection time in minutes. So, a value of 1 would terminate a connection after 1 minute. A value from 1 to 255 (to up 4.25 hours) can be used, with a value of 0 being OFF. The default should be 0 (OFF) for any WiModem made in the last couple of years. Doing a factory reset (AT&F) would definitely turn it off.
I will let you know when testing has concluded. It could happen later today.