06-02-2020, 05:55 AM
I got a bit more work done on this last evening. The DB37s will hopefully be here in a week or two so I can get some ribbon cables made up. I settled on the SCP and PS mounting locations, printed a SCP mount and installed those. After looking at the picture from the back I realized how close the PS was to the openings for the original IEC connectors. I can move the PS forward though. I also ordered a B female to mini B male adapter as I could not find a short USB B to mini B panel mount cable. I have several B to B on hand though.
I want to keep the original IEC connector holes accessible just in case the IEC interface for the SCP comes to fruition. Then I can pop a couple of DIN sockets there and have fun. One thing I did think of last evening though was how would one tell the SCP what drives were connected and/or which CMB drives to emulate?
I want to keep the original IEC connector holes accessible just in case the IEC interface for the SCP comes to fruition. Then I can pop a couple of DIN sockets there and have fun. One thing I did think of last evening though was how would one tell the SCP what drives were connected and/or which CMB drives to emulate?