10-09-2022, 05:58 PM
(10-03-2022, 03:27 AM)admin Wrote: With the EX jumper installed the drive will still read when there is no index pulse present. You do NOT need a switch. This is a permanent jumper setting that you always use no matter if you are reading the front side or the back side of a disk.
When this jumper is not installed, the drive REQUIRES the index pulse to be present for any type of read or write to work.
OH!!!! I see. I didn't understand that from what I read here on the forum. So, for most people with this drive, it's apparently a simple matter to move the factory-installed jumper on DX (or GX) to EX? Easy-peasy if so...
And just to clarify: having the EX jumper installed will not interfere with SCP reading (or writing?) in either Index or Splice modes?
Thanks.