09-21-2019, 06:46 PM
So I just bought a SCP along with the floppy drive cable. My intention was to use a single cable connected to my sony mpf902-1 and panasonic ju-475 in a case. But The cable end doesn't match the connector on the sony drive.
In the attached photo, you can see the cable that came with the sony drive and how the red wire connects to pin 1. This cable works fine with SCP. But If I line up pin 1 of the new cable I bought, it won't go into the sony drive due to the notch being in the incorrect spot. So this dual cable is useless to me. I'm lucky I noticed this before I actually tried to use my SCP.
Is this cable correct? And the sony connector is an oddball?
Is it pretty much impossible to have a single cable to SCP with these two drives?
In the attached photo, you can see the cable that came with the sony drive and how the red wire connects to pin 1. This cable works fine with SCP. But If I line up pin 1 of the new cable I bought, it won't go into the sony drive due to the notch being in the incorrect spot. So this dual cable is useless to me. I'm lucky I noticed this before I actually tried to use my SCP.
Is this cable correct? And the sony connector is an oddball?
Is it pretty much impossible to have a single cable to SCP with these two drives?