04-29-2019, 11:40 AM
Hi,
I'm using a WiModem232 with a Tandy 102 (simple TELCOM app) on the client side. I noticed that after you make a connection with ATDT/ATDP and go back to command mode (with +++), the connection is not dropped on an ATZ. With all modems that I've used, ATZ causes a hang-up but with WiModem232, you can do ATO after an ATZ reset, and it resumes the connection. I wonder, is this intentional? It could be useful for software that repeatedly issues ATZ commands.
Thanks, from Lex.
P.S. I've enabled notifications now, so I should respond a bit more quickly than I did last time (1-and-a-half months.. sigh..). :-)
I'm using a WiModem232 with a Tandy 102 (simple TELCOM app) on the client side. I noticed that after you make a connection with ATDT/ATDP and go back to command mode (with +++), the connection is not dropped on an ATZ. With all modems that I've used, ATZ causes a hang-up but with WiModem232, you can do ATO after an ATZ reset, and it resumes the connection. I wonder, is this intentional? It could be useful for software that repeatedly issues ATZ commands.
Thanks, from Lex.
P.S. I've enabled notifications now, so I should respond a bit more quickly than I did last time (1-and-a-half months.. sigh..). :-)