WiModem with 3.0 gets connected but loses connection
#5
(12-14-2018, 11:45 PM)admin Wrote: Just do a reset to defaults using AT&F<RETURN>.

That will restore everything back to defaults.  It could be the terminal program is looking at the carrier detect or something, which is changed as part of allowing Q-Link to run.

You can always go backwards in firmware to the previous version by typing AT*DOWNGRADE<RETURN>.



Eeek!! I think I remember seeing that in the manual.  But I guess I forgot about it.  I will see if it does the trick.  I will let you know if it works.

The AT*DOWNGRADE<RETURN> is a good one to know.

Thanks, 
-SF-
Reply


Messages In This Thread
RE: WiModem with 3.0 gets connected but loses connection - by Shadowfire - 12-16-2018, 02:22 PM



Users browsing this thread: 1 Guest(s)