02-01-2018, 04:57 PM
(This post was last modified: 02-01-2018, 05:45 PM by Baldrick.
Edit Reason: update
)
The asynchronous update is pretty good! I think I had asked for something like that in an earlier thread.
Now, I hate to be a pest but the latest firmware did not solve the explicit connect speed response issue.
I still don't get CONNECT 9600 in verbose mode or code 12 in non verbose mode.
Take a look at the command stream here:
here is the command stream and a remote connect in verbose mode (ATV1) and extended response on:
http://home.ca.inter.net/~henryp/IMG_2958.JPG
and here is the exact same command stream and a remove connect in non verbose mode (ATV0) and extended response on (ATX1)
http://home.ca.inter.net/~henryp/IMG_2957.JPG
Update:
I get correct verbose and non-verbose connect codes when dealing out, but not in auto-answer mode as shown in the linked images above.
Now, I hate to be a pest but the latest firmware did not solve the explicit connect speed response issue.
I still don't get CONNECT 9600 in verbose mode or code 12 in non verbose mode.
Take a look at the command stream here:
here is the command stream and a remote connect in verbose mode (ATV1) and extended response on:
http://home.ca.inter.net/~henryp/IMG_2958.JPG
and here is the exact same command stream and a remove connect in non verbose mode (ATV0) and extended response on (ATX1)
http://home.ca.inter.net/~henryp/IMG_2957.JPG
Update:
I get correct verbose and non-verbose connect codes when dealing out, but not in auto-answer mode as shown in the linked images above.