Non-verbose code discrepancy
#10
When you use ATX1 and verbose mode is off (ATV0), connect messages should be correct.  So, a connection at 9600 baud with ATX1V0 should give you a connect code of 12.  I will double-check this, but this is certainly how it should be.  That is the Hayes specification.
Reply


Messages In This Thread
Non-verbose code discrepancy - by Baldrick - 01-28-2018, 02:29 PM
RE: Non-verbose code discrepancy - by admin - 01-28-2018, 03:12 PM
RE: Non-verbose code discrepancy - by Baldrick - 01-28-2018, 03:21 PM
RE: Non-verbose code discrepancy - by admin - 01-28-2018, 03:26 PM
RE: Non-verbose code discrepancy - by Baldrick - 01-31-2018, 01:07 PM
RE: Non-verbose code discrepancy - by admin - 01-31-2018, 05:00 PM
RE: Non-verbose code discrepancy - by Baldrick - 01-31-2018, 05:09 PM
RE: Non-verbose code discrepancy - by admin - 01-31-2018, 05:13 PM
RE: Non-verbose code discrepancy - by Baldrick - 01-31-2018, 06:04 PM
RE: Non-verbose code discrepancy - by admin - 02-01-2018, 12:17 AM
RE: Non-verbose code discrepancy - by admin - 02-01-2018, 12:38 AM
RE: Non-verbose code discrepancy - by Baldrick - 02-01-2018, 05:16 AM
RE: Non-verbose code discrepancy - by admin - 02-01-2018, 01:21 PM
RE: Non-verbose code discrepancy - by Baldrick - 02-01-2018, 01:48 PM
RE: Non-verbose code discrepancy - by Baldrick - 02-01-2018, 04:57 PM
RE: Non-verbose code discrepancy - by admin - 02-01-2018, 09:05 PM
RE: Non-verbose code discrepancy - by admin - 02-01-2018, 11:36 PM
RE: Non-verbose code discrepancy - by Baldrick - 02-02-2018, 05:45 PM



Users browsing this thread: 1 Guest(s)