01-28-2018, 02:29 PM
I have been doing some experimentation with the WiModem232.
It is not playing nice with my BBS.
The software sets the modem to return non verbose responses (ATV0) and therefore expects a RING response to return a value 2 and CONNECT a value 1.
I checked and this is the standard from the Hayes reference manual, found here: https://archive.org/download/bitsavers_h...s_1993.pdf
However, the WiModem232 returns the RING command as 1 and the CONNECT command as 2. I tested the response with verbose responses and it does indeed return RING followed by CONNECT, but the non verbose codes appear to be backwards.
Is this an error in the firmware?
Henry
It is not playing nice with my BBS.
The software sets the modem to return non verbose responses (ATV0) and therefore expects a RING response to return a value 2 and CONNECT a value 1.
I checked and this is the standard from the Hayes reference manual, found here: https://archive.org/download/bitsavers_h...s_1993.pdf
However, the WiModem232 returns the RING command as 1 and the CONNECT command as 2. I tested the response with verbose responses and it does indeed return RING followed by CONNECT, but the non verbose codes appear to be backwards.
Is this an error in the firmware?
Henry