zterm/ccgms not working anymore after update to 2.x ?

[Amon_RA]

SOLVED : I forgot to set the baud rate back to 300 in zterm...

Hi,

I updated the firmware from v1.95 to v2.31 by entering ATUPDATE, but after the update zterm v1.0f is not returning any characters anymore...

I've set zterm to ASCII mode, and entered ATI but no letters are displayed on the screen and nothing is returned.
Dialing any BBS from the zterm phonebook also returns absolutely nothing anymore.

I switched to NovaTerm 9.0 and here I do get the correct output when I enter ati.
I entered at&f and an OK was returned.

I did however not fix the issues with zterm and the other terminal clients...

Is there a way I can downgrade the firmware back to v1.95 ?

[Amon_RA]

Found the issue.
I had to set the baud rate in zterm back to 300 in order to get the AT commands working again...
Changed the baud rate in zterm to 300, changed the baud rate of the wimodem to 2400 via AT*B2400 , chanced the baud rate in zterm back to 2400, did an AT&W, and now everything is fine again

[admin]

Yes, as noted in the manual the default baud rate is now 300 baud, not 2400 baud. When the update occurred it reset everything to factory defaults - including the new default baud rate.