01-05-2018, 01:18 PM
I am working on making an 'internal WiModem232' to do this I am going to use an Apple SSC and change the connector from female to a male end so that I can connect directly to the SSC card.
I want to then put a hood on the connector and use a thick double sided tape to mount that to the card (I am not sure if I am going to mount to front or rear yet).
My question is can the WiModem232 be powered by the d25 connector side? If so I count add to pins (assuming that its not already getting a ground) and tap the Apple connector buss for the +5v
Cooper
I want to then put a hood on the connector and use a thick double sided tape to mount that to the card (I am not sure if I am going to mount to front or rear yet).
My question is can the WiModem232 be powered by the d25 connector side? If so I count add to pins (assuming that its not already getting a ground) and tap the Apple connector buss for the +5v
Cooper