01-19-2021, 12:51 PM
Hey, I started using this a lot lately but have run in to an issue.
I've recently cut the UP9600 jumper so that I can use this on my C128D. It's been fine with terminals running at 2400 baud but I started using Desterm 3.02 at 9600 baud. All seems good with Telnet sites and file transfers but when I use WiBridge and issue a zget, the files begin to transfer but after a moment Desterm starts issuing errors. Checking changes from CRC-16 to CRC-32 or something and it basically stops transferring. I get a BAD CRC. The transfer on the PC side continues and I just get a screen of garbage on my terminal. Doesn't matter what baud rate I am using.
Wondering if there is a protocol issue or some other setting I can tweak. Just to be clear, it seems to be fine with
I've recently cut the UP9600 jumper so that I can use this on my C128D. It's been fine with terminals running at 2400 baud but I started using Desterm 3.02 at 9600 baud. All seems good with Telnet sites and file transfers but when I use WiBridge and issue a zget, the files begin to transfer but after a moment Desterm starts issuing errors. Checking changes from CRC-16 to CRC-32 or something and it basically stops transferring. I get a BAD CRC. The transfer on the PC side continues and I just get a screen of garbage on my terminal. Doesn't matter what baud rate I am using.
Wondering if there is a protocol issue or some other setting I can tweak. Just to be clear, it seems to be fine with