Q-link not logging on
#1
I've follow the instructions to connect to Quantum Link.  The connection process completes (WiModem says it is connected) and the Q-Link software brings me to the main Q-link page and says Waiting for Quantum Link.  I can type into the text area at the bottom but it just sits there for a while until it says Connection Reset, Press F5 to return to basic.  Which is the only thing I can do at that stage.  The WiModem still shows that it is connected to q-link.net however.
Reply
#2
Sounds like Q-link is not responding. I will test it myself.
Reply
#3
I was able to log into Q-Link today with no problems. I went through the various departments and was able to chat to the IRC c64friends portal.
Reply
#4
(03-16-2017, 10:08 AM)admin Wrote: I was able to log into Q-Link today with no problems.  I went through the various departments and was able to chat to the IRC c64friends portal.

Hmmm..ok thanks.  I'll try again tonight but I know it was not working for me last night.  Can you verify these steps;

Open my terminal

At*b1200 - set baud
at*c0 

Load Q-link disk

I've already set AT&SN0=5551212,q-link.net:5190
Reply
#5
Not quite:

AT*B1200
AT&C0

You also have the url in the spoofing wrong. It should be:

AT&SN0=5551212,QLINK.LYONLABS.ORG:5190
Reply
#6
(03-16-2017, 10:45 AM)admin Wrote: Not quite:

AT*B1200
AT&C0

You also have the url in the spoofing wrong.  It should be:

AT&SN0=5551212,QLINK.LYONLABS.ORG:5190
Still no dice.  I used that URL before, both connect but it just says Waiting for Q-Link.  After a few mins says connection reset but the WiModem shows connected.  argh....  if I switch to a terminal and hit hit it responds with Terminal= which means its connected according to the Q-link site.
Reply
#7
Maybe your Q-Link disk needs to be validated? You can do that using the connection setup program.
Reply
#8
(03-16-2017, 08:01 PM)admin Wrote: Maybe your Q-Link disk needs to be validated?  You can do that using the connection setup program.

So here is something interesting.  I swapped out my 1541 with my 1571 (for unrelated testing) and Q-link started working.  I think you were on to something about disk validation.  In any case....all good thanks for the help.
Reply




Users browsing this thread: 1 Guest(s)