02-11-2017, 10:13 AM
Hello, hope you don't mind me starting a new CommodoreServer thread. That one seems to be more general information.
I'm able to connect @2400 baud with no problems, it works well. Now I'm trying to connect using the 38400 baud driver, and need a little help getting it fully working.
Here's what I'm doing:
1) Go into terminal
2) Execute commands:
AT&K1
AT*R0
AT*C0
AT*B38400
3) Exit terminal via soft reset
4) Load V-1541 38400 (and execute)
5) Execute 'connect' program which executes PRINT#2,"ATDTCOMMODORESERVER.COM:1541"
At this point the WiModem shows "connected" on LED panel. I can execute commands to device #2, for example: LOAD"$",2
However, the output appears corrupted. For the above command, the first part of the directory listing is missing, then some junk characters, then finally the end of the listing is displayed normally.
Can anyone please help? I feel like I'm really close to getting this working. I've tried using different settings for RTS/CTS/DCD and none resolve the issue.
Thanks!
I'm able to connect @2400 baud with no problems, it works well. Now I'm trying to connect using the 38400 baud driver, and need a little help getting it fully working.
Here's what I'm doing:
1) Go into terminal
2) Execute commands:
AT&K1
AT*R0
AT*C0
AT*B38400
3) Exit terminal via soft reset
4) Load V-1541 38400 (and execute)
5) Execute 'connect' program which executes PRINT#2,"ATDTCOMMODORESERVER.COM:1541"
At this point the WiModem shows "connected" on LED panel. I can execute commands to device #2, for example: LOAD"$",2
However, the output appears corrupted. For the above command, the first part of the directory listing is missing, then some junk characters, then finally the end of the listing is displayed normally.
Can anyone please help? I feel like I'm really close to getting this working. I've tried using different settings for RTS/CTS/DCD and none resolve the issue.
Thanks!