Latest firmware
#3
If I order my board this week will I have this problem?

(12-20-2013, 01:28 PM)admin Wrote: ATTENTION!! PLEASE UPDATE TO FIRMWARE v0.4!

There was a bug in the RAM test routine that resulted in only 64K pages being tested! This problem was discovered during testing of production boards where there was clearly a solder bridge between two of the pins of the RAM chip which should have resulted in a RAM test failure. After correcting the code, we found two boards out of the first box of 100 units that failed the RAM test due to solder bridges. We are testing the rest of our inventory to see how much of a problem this was with our first production run.

If after you update the firmware you see all 3 LED's flashing, it means that the RAM test is failing. Unfortunately, unless you see an obvious solder bridge like we did and can fix it, the board will have to come back to us for replacement. Hopefully, nobody has this issue!
Reply


Messages In This Thread
Latest firmware - by admin - 11-06-2013, 02:38 PM
RE: Latest firmware - by admin - 12-20-2013, 01:28 PM
RE: Latest firmware - by videofx - 12-20-2013, 07:58 PM
RE: Latest firmware - by admin - 12-20-2013, 08:16 PM
RE: Latest firmware - by videofx - 12-20-2013, 09:58 PM
RE: Latest firmware - by admin - 12-21-2013, 08:36 AM
RE: Latest firmware - by videofx - 12-21-2013, 10:25 AM
RE: Latest firmware - by admin - 12-21-2013, 11:58 AM
RE: Latest firmware - by videofx - 12-21-2013, 02:01 PM
RE: Latest firmware - by admin - 12-24-2013, 03:49 PM
RE: Latest firmware - by admin - 01-25-2014, 10:38 AM
RE: Latest firmware - by admin - 03-17-2014, 02:27 PM
RE: Latest firmware - by admin - 08-14-2015, 09:23 AM
RE: Latest firmware - by admin - 04-27-2022, 01:18 PM



Users browsing this thread: 1 Guest(s)