odd thing..

[DarkLord]

You SHOULD be using AT&K1 with anything over 2400 baud.  AT&K0, AT&K2, and AT&K3 all turn OFF the hardware flow control.  You WANT that on for your BBS.  Without the hardware flow control, you will have errors sending any large chunks of data when the receiver is telling the sender to stop sending data.

(From the WiModem232 PDF)

AT&K[x] – Get/Set hardware flow control mode [0/1/2/3]
This command will change the hardware handshaking mode. 0 = off, 1+ = on. Default is 0

Jim, just wondering...with the next revision of the WiModem232 PDF, could you change the above entry to:

"0 = off, 1 = on, 2 = off, 3 = off", or something like that, to make it perfectly clear for simpletons such as myself?

Reading the original entry I absolutely took it as 0 turned it off and everything else turned it on.

Thanks!