Hey Jim. I'm having a real problem here after this latest update. I updated all 3 of my WiModem232's and according to the text, it went fine.
On the WiModem232 that I have on the Mega ST4 that runs my BBS, it's working fine for all *incoming* calls. There doesn't seem to be any problem on that end.
However, on the other 2 WiModem232's, whenever I use them to call *out* to my BBS, they work for so long, then it's like the WiModem232 drops back down to the initial startup mode where you can type the usual AT<whatever> commands. The call, meanwhile, is still connected to the BBS, but you can no longer give it commands. When it does this, an "OK" prompt is shown on the screen. I'm going to attach some screenshots to show what I mean. Also, and now it gets really weird, after it does this the "ATI" command says it has new firmware waiting again. Mind you, I've already updated it. I can unplug the WiModem232 and restart it and the new firmware message goes away. At least it does until I try to call the BBS again then it goes through the same cycle. I did try updating again and it reports that it's successful (again) but it didn't fix the problem.
Thanks, and sorry that I always seem to be the poster child for odd problems!
On the WiModem232 that I have on the Mega ST4 that runs my BBS, it's working fine for all *incoming* calls. There doesn't seem to be any problem on that end.
However, on the other 2 WiModem232's, whenever I use them to call *out* to my BBS, they work for so long, then it's like the WiModem232 drops back down to the initial startup mode where you can type the usual AT<whatever> commands. The call, meanwhile, is still connected to the BBS, but you can no longer give it commands. When it does this, an "OK" prompt is shown on the screen. I'm going to attach some screenshots to show what I mean. Also, and now it gets really weird, after it does this the "ATI" command says it has new firmware waiting again. Mind you, I've already updated it. I can unplug the WiModem232 and restart it and the new firmware message goes away. At least it does until I try to call the BBS again then it goes through the same cycle. I did try updating again and it reports that it's successful (again) but it didn't fix the problem.
Thanks, and sorry that I always seem to be the poster child for odd problems!