hi
sometimes the bbs would become unresponsive and I would like to disconnect.
ccgms says c= STOP will go off-hook and shift-STOP will disconnect (non-hayes) both of which does not seem to do anything.
I tried doing AT&D2 and AT&D3 no difference was noticed.
any suggestion on how i can get this to work or at least investigate if this analog telephone specific functionality that wimodem is emulating?
too quickly investigate and not cause on one of the bbs. i do the following
1. after a power cycle
2. AT&D2 DTR signal is monitored. The modem hangs up and enters command state after an on-to-off transition of DTR signal.
3. ATDT google.com:80 i get a CONNECT
4. press shift-STOP ... i see Disconnected
5. AT ... i am suppose to be in command state and get "OK" but i get nothing
6. press c= STOP also nothing
7. +++ i get "OK" i am guessing only now am i in command mode
8. AT ... i get OK
sometimes the bbs would become unresponsive and I would like to disconnect.
ccgms says c= STOP will go off-hook and shift-STOP will disconnect (non-hayes) both of which does not seem to do anything.
I tried doing AT&D2 and AT&D3 no difference was noticed.
any suggestion on how i can get this to work or at least investigate if this analog telephone specific functionality that wimodem is emulating?
too quickly investigate and not cause on one of the bbs. i do the following
1. after a power cycle
2. AT&D2 DTR signal is monitored. The modem hangs up and enters command state after an on-to-off transition of DTR signal.
3. ATDT google.com:80 i get a CONNECT
4. press shift-STOP ... i see Disconnected
5. AT ... i am suppose to be in command state and get "OK" but i get nothing
6. press c= STOP also nothing
7. +++ i get "OK" i am guessing only now am i in command mode
8. AT ... i get OK