12-14-2021, 08:55 AM
After a cold start:
I open SCP software (version 2.20) from the desktop icon
A Windows-10 dialog asks if I want to allow SCP to make changes; I agree
SCP starts and immediately says a new version is available, asking do I want to install it; I agree
Shortly - a few seconds - thereafter a dialog states installation is finished
I close the dialog and another pops up stating SCP is already running; cancel is my only option
I close this dialog and nothing further happens; SCP does not load
This happens every time I invoke SCP software
If, however, I opt not to install the new version SCP loads and acts as usual.
???
-CH-
I open SCP software (version 2.20) from the desktop icon
A Windows-10 dialog asks if I want to allow SCP to make changes; I agree
SCP starts and immediately says a new version is available, asking do I want to install it; I agree
Shortly - a few seconds - thereafter a dialog states installation is finished
I close the dialog and another pops up stating SCP is already running; cancel is my only option
I close this dialog and nothing further happens; SCP does not load
This happens every time I invoke SCP software
If, however, I opt not to install the new version SCP loads and acts as usual.
???
-CH-