08-04-2021, 02:43 AM
The AT*REBOOT command was removed.
AT&F works fine. I actually use it for every single WiModem232 before it ships. The baud rate is NOT immediately reset when you use AT&F. Power off the modem and power it back on and it will then be at 300 baud.
Make sure that you don't have a firewall in your router - and that you don't have a PiHole setup without an exclusion.
AT&F works fine. I actually use it for every single WiModem232 before it ships. The baud rate is NOT immediately reset when you use AT&F. Power off the modem and power it back on and it will then be at 300 baud.
Make sure that you don't have a firewall in your router - and that you don't have a PiHole setup without an exclusion.