MT32-PI connexion

[srousseau]

Thanks.  I'm looking at the SEB manual and I'm confused.

Page 9 Header H2 Pin 1 = FPGA PIN_AG11 = Arduino IO15
but
Page 9 Header SER Pin 1 = FPGA PIN_AH9 = Arduino IO15

I have the same confusion with

Page 9 Header H2 Pin 2 = FPGA PIN_AH9 = Arduino IO14
but
Page 9 Header SER Pin 2 = FPGA PIN_AG11 = Arduino IO14


I have build this table to have a big picture:

DE10-NANO.           SEB                      RPI            MiSTer signal
IO15/SCL                 H2 - 1 - SCL        3                I2C SDA
IO14/SDA                 H2 - 2 - SDA       10              TX (MIDI out)
GND                         H2 - 4 - GND       6                GND
IO13/D13/SCK         SER - 5 - SCK      35              I2S WS
IO12/D12/MISO.      SER - 6 - MISO    5                I2C SCL
IO11/D11/MOSI                                   12               I2S BCLK
IO10 /D10/SS                                       40               I2S DAT
IO8/D8                                                  8*               RX (MIDI in)
VCC5                        P2 - 7 - 5V.          2                 +5V

1. To connect a MT32-PI to SEB I need to know where to find Arduino IO14 and Arduino IO15 but I'm not sure where they are.

2. I also need to know where to find Arduino IO10/SS and Arduino IO11/MOSI and I didn't find them on SEB.