Possible to downgrade firmware?
#11
Ok, I pinged your setup using 6400 instead of 6401 and it connected.  So, I am guessing that your port is just set wrong?  Look at your screen shot that you posted, you can see the port is set to 6400, not 6401.
Reply


Messages In This Thread
Possible to downgrade firmware? - by Amon_RA - 01-10-2021, 01:10 PM
RE: Possible to downgrade firmware? - by admin - 01-10-2021, 03:06 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-22-2021, 09:14 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-23-2021, 05:40 PM
RE: Possible to downgrade firmware? - by admin - 01-11-2021, 06:55 PM
RE: Possible to downgrade firmware? - by admin - 01-12-2021, 02:43 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 12:42 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-23-2021, 06:30 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 09:02 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-23-2021, 11:30 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 09:04 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-23-2021, 11:34 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 09:21 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 09:42 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 09:55 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-23-2021, 11:39 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 11:47 PM
RE: Possible to downgrade firmware? - by admin - 01-23-2021, 11:56 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-24-2021, 12:05 AM
RE: Possible to downgrade firmware? - by admin - 01-24-2021, 12:53 AM
RE: Possible to downgrade firmware? - by admin - 01-24-2021, 12:56 AM
RE: Possible to downgrade firmware? - by admin - 01-24-2021, 05:05 AM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-24-2021, 10:39 AM
RE: Possible to downgrade firmware? - by admin - 01-24-2021, 01:27 PM
RE: Possible to downgrade firmware? - by Mr.Micro - 01-24-2021, 03:34 PM



Users browsing this thread: 1 Guest(s)