12-22-2020, 02:16 PM
I've been trying to 3d print the case from the download area for my wimodem232 oled, I was able to print the case bottom
no problem but the upper case just prints in a huge mess. I've tried it several times with the same result, I am using an Ender 3 pro
with a 4mm nozzle, am I doing something wrong or is there an issue with the stl file?
Rob.
no problem but the upper case just prints in a huge mess. I've tried it several times with the same result, I am using an Ender 3 pro
with a 4mm nozzle, am I doing something wrong or is there an issue with the stl file?
Rob.