09-27-2020, 09:30 AM
Yes, on power up the red LED will flash for a few seconds and then go out and the green LED comes on. The blue LED doesn't come on (unless you are in firmware update mode as you noticed previously) so it seems you have power.
You stated you tried without attaching the board. Have you tried running the program with the board attached, but the drive NOT attached to see if the update firmware message appears? If it doesn't, then I would think this is some type of USB power problem. Maybe the drive you are trying to use is drawing more power than your USB port can handle.
You stated you tried without attaching the board. Have you tried running the program with the board attached, but the drive NOT attached to see if the update firmware message appears? If it doesn't, then I would think this is some type of USB power problem. Maybe the drive you are trying to use is drawing more power than your USB port can handle.