Ways to implement a selectable 3rd drive
#4
You could go with a single 37 pin output connector wired from inside your case, and use the extra three pins tied to +5v, +12v, and ground.  On the external drive side you would use a 37 pin connector wired to a 34 pin ribbon cable, along with the power wires (molex/berg connectors?) to the drive.  This would allow for 5.25" and 3.5" drives to be used.
Reply


Messages In This Thread
RE: Ways to implement a selectable 3rd drive - by admin - 05-21-2020, 04:49 PM



Users browsing this thread: 1 Guest(s)