CBMSTUFF FORUM › CBMSTUFF PRODUCTS › SuperCard Pro › Installation and setup v
"Supercard Hardware in Update Mode" despite not

Linear Mode
"Supercard Hardware in Update Mode" despite not
tenyuhuang Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Mar 2020
#5
03-04-2020, 02:48 PM
(03-04-2020, 09:05 AM)admin Wrote: As stated in the manual, the jumper is only necessary for updating firmware.  You should never have it plugged into the board during normal usage.
But the manual says "re-insert JP1 after flashing":
   
Find
Reply


Messages In This Thread
RE: "Supercard Hardware in Update Mode" despite not - by tenyuhuang - 03-04-2020, 02:48 PM



Users browsing this thread: 1 Guest(s)