Files go missing
#8
(09-08-2019, 04:40 PM)morduk2 Wrote: I put all the disk images (7) of Page Stream into the Drawer :Amiga files\Shared\dir\work\software.  I click disk one to open and it opens up Workdench 3.1 with the image of disk 1.   I click open disk 1 and the only option I am given is to install the program.  I click on install and am given the drawer Workbench 3.1: Tried to install the program in that drawer and get the message "Not enough memory"  I get similar results with any multi-disk program I attempt to use.  I am missing something here and I can't figure it out!

How much memory do you have on the emulated Amiga? It might be that you need to provide more if there isn't enough (can happen if you have a high-resolution high-colour graphics mode in use or a lot of programs running in the background). You should be able to do this in the emulator's settings.

Another possibility is that you have too much memory. A lot of older and poorly written software are not able to recognise massive amounts of memory so the values that get reported back to the software end up being a negative number. Usually 4 or 8 meg of Fast RAM is a good place to start.

Kind regards,

Francis
Dreamland Fantasy Studios
http://www.dfstudios.co.uk
Reply


Messages In This Thread
Files go missing - by morduk2 - 09-01-2019, 05:30 PM
RE: Files go missing - by admin - 09-01-2019, 07:50 PM
RE: Files go missing - by dfstudios - 09-02-2019, 10:56 AM
RE: Files go missing - by morduk2 - 09-06-2019, 05:44 PM
RE: Files go missing - by admin - 09-07-2019, 03:15 PM
RE: Files go missing - by morduk2 - 09-08-2019, 04:40 PM
RE: Files go missing - by dfstudios - 09-14-2019, 06:59 AM
RE: Files go missing - by admin - 09-09-2019, 03:32 PM



Users browsing this thread: 1 Guest(s)