Protective case
#6
It's designed to sit open on its custom made rubber feet. They don't allow the board to move around on a desk. I don't have any plans to make a plastic enclosure, but I might when the 1541 emulation is done because I would like to protect the IEC connector.
Reply


Messages In This Thread
Protective case - by kentsu - 12-25-2013, 11:59 AM
RE: Protective case - by videofx - 12-25-2013, 12:54 PM
RE: Protective case - by kentsu - 12-25-2013, 01:40 PM
RE: Protective case - by admin - 12-25-2013, 02:45 PM
RE: Protective case - by kentsu - 12-25-2013, 05:56 PM
RE: Protective case - by admin - 12-25-2013, 10:17 PM
RE: Protective case - by videofx - 12-26-2013, 07:26 AM
RE: Protective case - by admin - 12-26-2013, 09:24 PM
RE: Protective case - by videofx - 12-26-2013, 11:18 PM



Users browsing this thread: 1 Guest(s)