Can I get a repair after you receive the SCP board?
The cause of the failure is that of the data cable of the floppy drive.
The connection direction is wrong and it is broken due to reverse current.
SCP cards are recognized by Windows 10.
However, not all floppy drives are recognized.
The data cable for the floppy drive is 5.25-inch and 3.5-inch
But the problem was that the cable could not identify the direction.
As soon as I connected the data cable to the 5.25 inch drive
I checked the board's chipset for a bit of smoke.
Anyway, I sent SCP card to your address by EMS.
(Of course I attached message with SCP card)
I personally want my SCP card to be repaired.
https://www.cbmstuff.com/forum/showthrea...hlight=bus
I also checked that the interface chips should never get hot.
That seems to be only possible with a bus problem when I seek the floppy drive.
Except this problem, SCP interface seems to work well.
The cause of the failure is that of the data cable of the floppy drive.
The connection direction is wrong and it is broken due to reverse current.
SCP cards are recognized by Windows 10.
However, not all floppy drives are recognized.
The data cable for the floppy drive is 5.25-inch and 3.5-inch
But the problem was that the cable could not identify the direction.
As soon as I connected the data cable to the 5.25 inch drive
I checked the board's chipset for a bit of smoke.
Anyway, I sent SCP card to your address by EMS.
(Of course I attached message with SCP card)
I personally want my SCP card to be repaired.
https://www.cbmstuff.com/forum/showthrea...hlight=bus
I also checked that the interface chips should never get hot.
That seems to be only possible with a bus problem when I seek the floppy drive.
Except this problem, SCP interface seems to work well.