09-15-2020, 02:39 PM
(This post was last modified: 09-15-2020, 02:42 PM by Duboun.
Edit Reason: the pictures didn't work
)
(09-15-2020, 01:35 PM)admin Wrote: The serial port is whatever speed you set it to. At 300 baud, that is about 33.3ms per byte. I suppose depending on the amount of overhead you had it could be 50ms per byte. The serial port supports up to 1.25 mbps. What baud rate are you trying to use?
I am doing some final testing right now on the SD card support, because I will be implementing the ability to load/save using the SD card and also have enable the option to make SuperCard Pro a disk drive emulator.
That would be really cool if it could run as drive emulator...
I was using default baudrate (250000), but I also tried others (19200, 500000) and it was the same.
The device communicate on the specified baudrates, but the 50ms delay between every byte received does not change.
Captured data
Captured data closeup