12-16-2018, 02:22 PM
(This post was last modified: 12-16-2018, 02:53 PM by Shadowfire.)
(12-14-2018, 11:45 PM)admin Wrote: Just do a reset to defaults using AT&F<RETURN>.
That will restore everything back to defaults. It could be the terminal program is looking at the carrier detect or something, which is changed as part of allowing Q-Link to run.
You can always go backwards in firmware to the previous version by typing AT*DOWNGRADE<RETURN>.
Eeek!! I think I remember seeing that in the manual. But I guess I forgot about it. I will see if it does the trick. I will let you know if it works.
The AT*DOWNGRADE<RETURN> is a good one to know.
Thanks,
-SF-