08-17-2018, 09:11 AM
Hi Jim,
The Wimodem232 displayed a firmware update notification this evening (2.94 I'm assuming). Initiated the update as per usual. The progress bar began to increase, but then it went weird and began to fill the entire screen. Purple light was also flashing slightly. Was like this for 15 minutes. Switched it off and then back on and it is now dead as a doornail. Just get a blue flashing light. Included a photo of the screen before turning it off and on again.
Is there a way to emergency flash the device? Thanks.
The Wimodem232 displayed a firmware update notification this evening (2.94 I'm assuming). Initiated the update as per usual. The progress bar began to increase, but then it went weird and began to fill the entire screen. Purple light was also flashing slightly. Was like this for 15 minutes. Switched it off and then back on and it is now dead as a doornail. Just get a blue flashing light. Included a photo of the screen before turning it off and on again.
Is there a way to emergency flash the device? Thanks.