Q-Link connecting problem
#5
(08-22-2018, 05:49 PM)admin Wrote: Did you follow the Q-Link information below?

https://www.cbmstuff.com/forum/showthread.php?tid=329

A lot of people miss the fact that DCD must be set to on or Q-Link will ignore the connection, just like what you describe.

I did follow that information, and in the first post here I included the results of AT&V  which shows a status of "&C0" which I believe from the manual and the post you linked to mean that DCD is always on.  Also Baud rate is shown to be 1200 and using the spoofed number a successful connect is shown. 

For the next step I will try an unvalidated Q-Link disk.  Thank you for your help as I trouble-shoot this problem.
Reply


Messages In This Thread
Q-Link connecting problem - by Sprite9 - 08-07-2018, 08:24 PM
RE: Q-Link connecting problem - by admin - 08-07-2018, 10:24 PM
RE: Q-Link connecting problem - by Sprite9 - 08-22-2018, 04:39 PM
RE: Q-Link connecting problem - by admin - 08-22-2018, 05:49 PM
RE: Q-Link connecting problem - by Sprite9 - 08-27-2018, 06:55 PM
RE: Q-Link connecting problem - by Sprite9 - 09-12-2018, 08:39 PM
RE: Q-Link connecting problem - by admin - 08-28-2018, 12:51 PM
RE: Q-Link connecting problem - by admin - 09-12-2018, 10:21 PM



Users browsing this thread: 1 Guest(s)