Q-Link connecting problem
#1
Connecting to Q-Link was working before I upgraded to Firmware 2.93.  It is odd because I can get a connect response by issuing the command (in ccgms): ATDT 5551212, but running Q-Link never finishes connecting.  I've attached a photo of the results of commands ati, atdt 5551212 and at&v.
   
Reply


Messages In This Thread
Q-Link connecting problem - by Sprite9 - 08-07-2018, 08:24 PM
RE: Q-Link connecting problem - by admin - 08-07-2018, 10:24 PM
RE: Q-Link connecting problem - by Sprite9 - 08-22-2018, 04:39 PM
RE: Q-Link connecting problem - by admin - 08-22-2018, 05:49 PM
RE: Q-Link connecting problem - by Sprite9 - 08-27-2018, 06:55 PM
RE: Q-Link connecting problem - by Sprite9 - 09-12-2018, 08:39 PM
RE: Q-Link connecting problem - by admin - 08-28-2018, 12:51 PM
RE: Q-Link connecting problem - by admin - 09-12-2018, 10:21 PM



Users browsing this thread: 1 Guest(s)