06-25-2022, 12:52 PM
(06-25-2022, 12:10 AM)neal@layton.org Wrote: >DanW
>It would be connected to a wimodem232
Then start with the straight thru cable
If that doesn't work try this
SSC -------------------------- Modem
---------------------------------------------
GND 1 ----------------- 1 GND frame ground (this line is OPTIONAL)
TXD 2 ----------------> 2 TXD transmit data (from SSC to modem)
RXD 3 <---------------- 3 RXD receive data (from modem to SSC)
RTS 4 ----------------> 4 RTS request to send (for hardware handshaking)
CTS 5 <---------------- 5 CTS clear to send (for hardware handshaking)
DSR 6 <---------------- 8 DCD data carrier detect (from modem)
GND 7 ----------------- 7 GND signal ground (for all signals but pin 1)
DCD 8 (leave unconnected!)
DTR 20 ----------------> 20 DTR data terminal ready (to hangup modem)
Have the ends of this cable labelled "SSC" and "Modem", as it will not work correctly if plugged in backwards
Gracias. One more question: do I set the super serial card to "terminal" or "modem"?