CBMSTUFF FORUM › CBMSTUFF PRODUCTS › SuperCard Pro › Hardware v
step time

Linear Mode
step time
hwrdmltn Offline
Junior Member
**
Posts: 12
Threads: 3
Joined: Jan 2018
#1
02-14-2018, 09:45 PM
In some of my restorations, I have a BASF 5.25 drive SSDD (I believe the DEC Rainbow used these) - my problem is that the drive is the older type stepper, similar in fact to the Disk ][ stepper arrangement, very slow and cumbersome to overcome it's stand-still inertia - it needs more time between steps as is programmable in the WD17XX series chips. Is there any way this timing can be changed through the config file?
Thanks

W1ARQ  Howard
Find
Reply


Messages In This Thread
step time - by hwrdmltn - 02-14-2018, 09:45 PM
RE: step time - by admin - 02-15-2018, 12:22 AM
RE: step time - by hwrdmltn - 02-15-2018, 09:44 AM
RE: step time - by admin - 02-15-2018, 08:03 PM
RE: step time - by hwrdmltn - 02-16-2018, 06:13 AM
RE: step time - by SomeGuy - 02-16-2018, 05:35 PM
RE: step time - by admin - 02-17-2018, 12:36 AM
RE: step time - by hwrdmltn - 02-20-2018, 11:01 PM
RE: step time - by admin - 02-20-2018, 11:50 PM
RE: step time - by hwrdmltn - 02-21-2018, 05:58 AM
RE: step time - by admin - 02-21-2018, 11:16 AM
RE: step time - by hwrdmltn - 02-21-2018, 02:40 PM
RE: step time - by hwrdmltn - 02-21-2018, 03:11 PM
RE: step time - by admin - 02-21-2018, 03:21 PM
RE: step time - by hwrdmltn - 02-21-2018, 07:53 PM
RE: step time - by admin - 02-21-2018, 09:15 PM



Users browsing this thread: 1 Guest(s)