01-24-2018, 11:14 PM
Yes, I have already fixed the AT*LED command returning ERROR on any setting, good or bad. The next firmware update will have this fix.
The WiModem is designed to load and use the last settings that were stored. So, if you change the baud rate, LED brightness, etc. you need to store the current settings using the AT&W command. So, if you want your baud rate set to 9600 baud and have the WiModem boot with that baud rate, do the following:
AT*B9600 {RETURN}
AT&W {RETURN}
The WiModem is designed to load and use the last settings that were stored. So, if you change the baud rate, LED brightness, etc. you need to store the current settings using the AT&W command. So, if you want your baud rate set to 9600 baud and have the WiModem boot with that baud rate, do the following:
AT*B9600 {RETURN}
AT&W {RETURN}