01-23-2018, 01:56 PM
First off - thank you for this great product! It's been fantastic so far.
One issue i'm encountering in setting up a BBS is that the unit does not respond to hang up commands sent via the BBS software. I'm using Telegard on Tandy 1000 SX (IBM compatible), and when a user logs out the standard hang up command is not working.
I have tried setting the hang up parameters to "ATH|", and "+++ATH|" (| represents a carriage return), and from the remote connection it continues to stay connected.
Once the remote connection disconnects themselves, everything is fine again.
Any ideas what might be causing this, or perhaps i'm doing something wrong? It's a minor issue, but if you have any ideas I would greatly appreciated it.
One issue i'm encountering in setting up a BBS is that the unit does not respond to hang up commands sent via the BBS software. I'm using Telegard on Tandy 1000 SX (IBM compatible), and when a user logs out the standard hang up command is not working.
I have tried setting the hang up parameters to "ATH|", and "+++ATH|" (| represents a carriage return), and from the remote connection it continues to stay connected.
Once the remote connection disconnects themselves, everything is fine again.
Any ideas what might be causing this, or perhaps i'm doing something wrong? It's a minor issue, but if you have any ideas I would greatly appreciated it.