(01-08-2018, 06:55 PM)admin Wrote: OK, I am confused here. You said you received the WiModem232 but then you state you are using CCGMS, which is a C64 program - that would require the WiModem, not the WiModem232. Which do you actually have? DTR is not supported at all with the C64 version. I don't know what computer Cbase is for.
DTR and DSR are connected together with the WiModem232. DSR follows DTR. So, when DTR goes high, so will DSR. I am not sure how DTR/DSR would need to be set (in place of RTS/CTS).
Why would a C64 require or work with a Wimodem only ?
as said, Cbase BBS on C64 with Swiftlink.
If i wouldnt have a working 9600 Baud setup for, hmmm lemme think 20 Years or so i could understand that i am inventing something new. But as this is used back in the Days and at current from many Cbase Sysops (also easyly reachable Info via goolge) my question shouldnt be that hard. anyways
Swiftlink is the RS232 Cartridge that allows me to connect a Modem up to 115Kbaud
https://www.commodoreserver.com/BlogEntr...8C7F408538
Cbase is the C64 BBS System for C64
https://en.wikipedia.org/wiki/C*Base
I know what i recieved and what i want to use it for,else i wouldnt ask that :-)
So i am confused here too :-)In the Manul i read about the Hardware Flow Control (which i want to archieve) and the Jumper Pads. I have to cut DSR/CTS and DTR/RTS and not Bridge DSR/DTR
right ?