CBMSTUFF FORUM › CBMSTUFF PRODUCTS › SuperCard Pro › Installation and setup v
The drive LED doesn't go off

Linear Mode
The drive LED doesn't go off
jhons7 Offline
Junior Member
**
Posts: 6
Threads: 1
Joined: Nov 2017
#1
11-21-2017, 03:13 AM
The drive LED  come on during the scanning process that happens when the program first runs. But The drive LED doesn't go off and the floppy doesn't show up anywhere in the SCP software.

SC Pro. It has HW ver. 1.1, SW ver. 1.2.
Floppy drive is MPF920-5.

thanks for any help
Find
Reply


Messages In This Thread
The drive LED doesn't go off - by jhons7 - 11-21-2017, 03:13 AM
RE: The drive LED doesn't go off - by admin - 11-21-2017, 07:57 AM
RE: The drive LED doesn't go off - by jhons7 - 11-21-2017, 06:34 PM
RE: The drive LED doesn't go off - by admin - 11-22-2017, 09:13 AM
RE: The drive LED doesn't go off - by jhons7 - 11-22-2017, 09:16 PM
RE: The drive LED doesn't go off - by admin - 11-22-2017, 09:26 PM
RE: The drive LED doesn't go off - by jhons7 - 11-23-2017, 02:21 AM
RE: The drive LED doesn't go off - by admin - 11-23-2017, 08:17 AM
RE: The drive LED doesn't go off - by jhons7 - 11-24-2017, 03:54 AM
RE: The drive LED doesn't go off - by admin - 11-24-2017, 07:33 AM
RE: The drive LED doesn't go off - by admin - 12-19-2017, 11:20 AM
RE: The drive LED doesn't go off - by jhons7 - 12-19-2017, 06:29 PM
RE: The drive LED doesn't go off - by admin - 12-19-2017, 10:11 PM



Users browsing this thread: 1 Guest(s)