03-26-2017, 05:32 AM
(03-25-2017, 08:21 PM)admin Wrote: You can get rid of the SD slot you have because the SCP board uses a lift up cage, not a slide in card.I've never actually used the micro-SD slot, so I didn't try it, but that is why it is Rev. 1. I can certainly print in clear, or just add a small view port. I just used the filament that I had loaded. I also don't know if I have any clear ABS, and I definitely prefer ABS to PLA for cases. The opening in the top for the floppy cable could also stand to be about 0.5mm wider, but I am trying to decide if I like it like it is. It helps keep the lid on that end clicked in.
You should have this printed in transparent plastic so you can see the LEDs.