12-29-2016, 01:33 PM
(12-29-2016, 08:04 AM)admin Wrote: The manual was updated a few days ago to reflect the changes to the firmware.
As mentioned in the manual, you can not currently stack the AT commands together. So, you can not use ate1x1s0=0s10-30f1q0v1m0. You would need to make each of these individual AT commands. So, only ate1 (the echo mode) would be the only command executed.
The manual that is currently available for download is v1.5 for firmware v1.7.
It is not completely updated.
Examples I found:
1. On p13 in regards to S-Register commands, it still says only S2 and S12 are supported, while the following text also lists S0, which is necessary for auto answering calls.
2. On p13 it also says that ATA is unsupported while p14 in the FAQ it says that ATA is supported (as does p7).
However, my question was not about whether or not WiModem supports ATA, b/c I already know it does (I was only pointing out that the manual has not been completely updated). I wanted to know if anyone here actually has any experiences in running a real BBS on a real C64 using WiModem (preferably Color BBS), because I don't know how to configure this piece of software to get it working.
Cheers,
Christian.