07-28-2016, 06:53 PM
(07-15-2016, 08:49 AM)admin Wrote: Once V1541 is active, you just need type the following:
10 OPEN2,2,2
20 PRINT#2,"ATDTCOMMODORESERVER.COM:1541"
30 CLOSE2
RUN
When you run this program you should see it connect to Commodore Server. You can save this program to drive 8 by typing:
SAVE"NAME",8
You can change the "NAME" to any name you like.
Thanks. Does this just use whatever baud rate is set on the WiModem already? (I seem to recall that this OPEN statement would normally open a modem in 300 baud or lower. I'm not sure how modems or the WiModem work if you try communicating with them at a bps lower than what they're expecting.)