12-29-2015, 09:36 PM
(12-29-2015, 04:27 PM)admin Wrote: You don't need to. SuperCard Pro does that already unless you have a drive that requires the jumper change. An easy test is to run the SuperCard Pro software and go to the editor/analyzer and turn off the INDEX requirement for READs. Insert the back side of a disk and click on READ TRACK. If the track data shows up, then your drive will read the back side of a disk as it is. However, looking at your dump it appears that your drive needs the jumper mod.
Thanks-- any chance you have a pointer to the "jumper mod" in question? (I don't really see anything in the configuration jumpers that sounds promising, are we talking about a jumper wire or something?)
-Clay